BTT SKR v1.3/1.4/1.4Turbo Mainboard Case for Bear Frame by Hijinx

Diag Jumpers On Btt Skr. BTT SKR PICO Install and Configuration YouTube (Define DIAG_JUMPERS_REMOVED to suppress this warning.)" [-Wcpp] 706 | #warning "Motherboard DIAG jumpers must be removed when SENSORLESS_HOMING is disabled The firmware diag_pin is set to whatever the endstop_pin was and the endstop_pin is set to a virtual one [stepper_x] endstop_pin: ^PC0

(Define DIAG_JUMPERS_REMOVED to suppress this warning.)" [-Wcpp] 706 | #warning "Motherboard DIAG jumpers must be removed when SENSORLESS_HOMING is disabled Marlin\src\inc\Warnings.cpp:706:6: warning: #warning "Motherboard DIAG jumpers must be removed when SENSORLESS_HOMING is disabled

Bigtreetech Schematic Skr

I am using klipper and need to know what are the pin name for the diag pin for X and Y ( and other if there is ? Can you help me out ? If you are using Flymaker TMC2209 drivers, you need to enable the DIAG pin on the driver Therefore, it should be noted when using TMC2209 on the board with DIAG function :(such as SKR E3 DIP V1.0, BTT002 V1.0, SKR Pro V1.1, etc.)If you use the TMC2209 but needn't use the Shenzhen BIGTREE technology co., LTD.

Upgrade to SKR V1.4 Turbo TMC2209 BL Touch & BTT TFT35 V244826. SKR-RRF-E3 Diag Jumper Locations Config.g Changes. The firmware diag_pin is set to whatever the endstop_pin was and the endstop_pin is set to a virtual one [stepper_x] endstop_pin: ^PC0

BTT SKR v1.3/1.4/1.4Turbo Mainboard Case for Bear Frame by Hijinx. The DIAG pin of the TMC2130 can be used as an input/output, but the DIAG of the TMC2209 can only be used as an output If you want to use sensorless homing, a jumper needs adding under each driver you want to use it for as shown below